wood roof gable cap 2m unable to rotate when snapped,

4 votes

https://crytivo.atlassian.net/browse/FF-5060?atlOrigin=eyJpIjoiNjIzMzMxYzQ4ZmY5NGIzNGIwMzllNzRlYzhhMTA4OGIiLCJwIjoiaiJ9

when trying to make the wood roof gable cap 2m fit the right way on my roof i rotate it to fit, when it snaps it rotates on it own and i am now unable to rotate it again, this is before placing. i am able to rotate it when its not snapped.

Known Issue Building/Demolishing Low Priority Issue Suggested by: Tessa (04 Dec, '25) • Upvoted: 24 Dec, '25 • Comments: 5

Comments: 5
Oldest • Newest • Most likes • Fewest likes

04 Dec, '25
Tessa
Highlighted comment

i have a clip, not sure how to get it to you ATM
04 Dec, '25
Opa Admin
Would you mind adding a few screenshots or a clip to show us the issue visually?
05 Dec, '25
Fredrik Merged
It snaps into this position. And refuses to rotate any other way.
06 Dec, '25
Opa System
"Can't rotate Wood roof gable cap 2m" (suggested by <Hidden> on 2025-12-05), including upvotes (1) and comments (0), was merged into this suggestion.

20251205222423_1_eiaceb.jpg
10 Dec, '25
FlamingFelines
I had the same issue with the smaller version of that gable (where 3/4 edges are covered).

I was able to 'get around' the issue so to speak by removing any adjacent roof-tiles that did not 'contribute' to the gable, i.e. the corners but not the slanted roof pieces, and any roof tiles connected to a separate part of the roof but adjacent still. Then was able to place it the 'correct' direction, and place everything else back as needed.